Table of Contents
How do I clear the error code on my Canon printer?
Reset the Canon printer
- Switch on the printer.
- Press and hold the Stop/reset button.
- Press the button that you use to make a color copy and hold it down.
- Wait 5 seconds.
- The printer now reboots and sets itself up.
- Does the printer indicate that the device needs to be calibrated?
- You’ve reset your printer.
How do I reset my Canon printer manually?
1 Factory Reset
- Press Setup.
- Press the arrow buttons until you navigate to Device settings and then press OK.
- Press the arrow buttons until you navigate to Reset setting and then press OK.
- Press the arrow buttons until you navigate to Reset all and then press OK.
- Select Yes.
- Press OK. Your device is now reset.
Why does my Canon printer keep saying error?
If trying to print produces an error message on your computer, take note of it. Canon printers produce error codes for one of several reasons: The settings for your printer might not be compatible with the document you’re trying to print. The ink for your printer might be running low and may need to be replaced.
How do I fix the error code b203 on my Canon printer?
How can I fix Canon printer error b203?
- Perform a power cycle. At first, turn off your Canon printer.
- Check your ink cartridge. First of all, turn off your printer and make sure all the ink cartridges are full.
- Rule out a potentially bad network connection.
- Remove paper jam.
- Update drivers.
- Use Windows Troubleshooter.
How do I do a soft reset on my Canon printer?
Hold down the button (approximately 3 seconds) until HARD RESET is displayed. Holding down the button less than 3 seconds is the operation for SOFT RESET.
How do I factory reset my Canon Pixma printer?
How to Factory Reset a Canon Printer: Instructions
- Press Setup on your Canon device, then navigate to Device settings through arrow keys and press OK.
- Now, navigate to Reset setting, then press OK, and then navigate to Reset all option.
- Press OK, then select Yes, and therefore, your device is now reset.
How do I get a printer out of error state?
Sometimes, simply restarting both your computer and printer can be the solution to the “printer in error state” issue. Power off your printer and computer completely, leaving them in this state for a few minutes, then turn them on again to see if the problem is gone.