How much should a 4L60E rebuild cost?

How much should a 4L60E rebuild cost?

4l60e rebuild prices??? Typically it will be between $1800 & $2400 depending on the local labor rates. Make sure they are replacing the sunshell with ‘the beast’ sunshell and replace the steels as well. Some shops take a shortcut by reusing the steels that are in there which can cause premature failure.

How many hours does it take to rebuild an automatic transmission?

So how long does it take to rebuild a transmission? Most people need their cars running again as soon as possible. This can depend though, it can be done in as little as one day although the average is usually between three to four days.

How long does it take to install a rebuilt transmission?

It usually only takes a day or two to replace a transmission in most rear wheel vehicles. However, some late-model, front-wheel drive vehicles can be quite labor-intensive and take three to four days.

How long do 4L60E transmissions last?

4l60e from 1996 held up well. Reverse kinda was finicky, every now and than it would slip but had a good life. I honestly think around 250-300k it should be rebuilt if its original.

How many miles will a 4L60E last?

How many quarts of fluid to fill 4L60E at service?

The 4L60e’s fluid volume is 12 quarts (dry) of transmission fluid. This volume is based on a stock, with a 12 “torque converter,” shallow “transmission pan.” The ability of additional fluid will range from an extra quart or more with a deep pan.

Is a 4L60E interchangeable with a 4L80E?

FYI – 4L60E & 4L80E transmissions are NOT directly interchangeable. The wiring pinout of the trans plug is different, and 2 VSS’s are used versus 1 on the 4L60E. Besides the wiring difference, the ECM also requires a segment swap as that portion of the transmission control is completely different.

How many solenoid are there in a 4L60E transmission?

The 4L60E family of transmissions use 2 shift solenoids, initially called Shift Solenoid A & Shift Solenoid B, later changed to comply with OBD II (On Board Diagnostics revision 2) regulations to 1-2 Shift Solenoid & 2-3 Shift solenoid.

How many solenoids are the 4L60E?

There are 2 shift solenoids in a 4l60e (1-2 and 2-3), and both control up and downshifts with fluid passing through them when commanded to do so by the computer. However, when they go bad, you will notice very quickly. Your transmission will display a variety of symptoms, but sometimes these issues can be confused by other common 4l60e issues.